Septic Care


DrainMaster Pump


Pro Drain Chief II (Low Speed) by Viking Injector


7" X 7" w X 6 1/2D


  • 120 VAC, 5 Amps, 60 hrz.
  • Power Cord attached to unit
  • Optional Battery - powered unit available


  • Peristaltic type using 1/4" ID Squeeze tubing
  • Maximum lift - 20 ft vertical
  • Maximum PSA - 40 lbs.
  • Feed Rate (low speed) - 4.5 ft. oz. (133 ml.) per minute with 6 1/2 foot lift and push
  • Minimum injection - 1.5 fl. z. ( 44 ml.) @ 20 second run time
  • Maximum run time - 3 minutes


  • 24 hour repeat cycle - 1 minute activation interval
  • optional 7 day timer available


  • Wall mount, double key (drilling template included)
  • Surface mount: Rubber suction feet available
  • Complete installation hardware and instructions included
  • Security lock with key        
  • Heavy-duty lid hinge


DrainMaster5-gallon pail
Follow manufacturer's installation instructions
  1. Remove safety cap from spout on lid of pail
  2. Remove black, screw-on resealing cap
  3. Pull ring and remove inner spout cap
  4. Locate ring of plastic on spout
  5. Using a sharp knife cut spout just below the ring
  6. Break apart the three sections of snap-together dip tube and snap sections together to make a single 17 5/8 tube.
  7. Push the assembled tube through the spout, slotted end first (slotted end goes to the bottom of pail, flush side protrudes approximately 3" above the pail lid. This will fit tightly.
  8. Insert square plastic piece with compression fitting into protruding end of dip tube.
  9. Connect one end of tubing to dip tube compression fitting and other end to compression fitting on supply side of pump.


Back to Top

DrainMaster Pump Installation download/view

For technical questions and comments regarding this website,
please contact the Webmaster.